Product ID:SOFT SOLDER FLUX-ACTIVE ACID
MSDS Date:02/17/1997
FSC:3439
NIIN:00-250-2629
MSDS Number: CCLPV

AMERICAN CHEMICAL & FLUX PRODUCTS

5722 UNION PACIFIC AVE
LOS ANGELES, CA 90022
US

Emergency Phone: 213-723-0713

Info Phone: 213-723-0713

Cage: OBTX0

SPECIALTY WELDING SUPPLY

UNKNOW SPARKS, NV 89431 US

Telephone: 702-356-6988

Cage: 09654

ZINC CHLORIDE (SARA 313) (CERCLA)

CAS: 7646-85-7

RTECS: ZH1400000

OSHA PEL 1 MG/M3

ACGIH TLV: 1MG/M3/2STEL(FUME)96

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

WATER (DEIONIZED)

CAS: 7732-18-5

RTECS: ZC0110000

OSHA PEL NOT RELEVANT

ACGIH TLV: NOT RELEVANT

AMMONIUM CHLORIDE (CERCLA)

CAS: 12125-02-9

RTECS: BP4550000

OSHA PEL 10 MG/M3

ACGIH TLV: 10 MG/M3 FUME; 9596

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

HYDROGEN CHLORIDE (HYDROCHLORIC ACID) (SARA 302/313)

CAS: 7647-01-0

RTECS: MW4025000

OSHA PEL C 5 PPM

ACGIH TLV: C 5 PPM; 9596

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

METHYL ORANGE(BENZENESULFONIC

CAS: 547-58-0

RTECS: DB6327000

OSHA PEL NOT ESTABLISHED.

ACGIH TLV: NOT ESTABLISHED.

LD50 LC50 Mixture:LD50 (ORAL, RAT) IS NOT RELEVANT.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:TARGET ORGANS:EYE, SKIN, RESPIRATORY &
GI TRACTS. ACUTE- CORROSIVE. CAN CAUSE EYES, SKIN, RESPIRATORY & GI
TRACTS SEVERE IRRITATION & BURNS. FUMES & GASES FROM WELDING CAN BE
DANGEROUS TO YOUR HEALTH. ARC RAYS CAN INJURE EYES & BURN SKIN.
OVEREXPOSURE MAY CAUSE DIZZINESS, CHEST PAIN. CHRONIC- AFFECTS
PULMONARY FUNCTION
Explanation of Carcinogenicity:NONE
Effects of Overexposure:SEVERE IRRITATION AND BURNS, COUGHING, CHOKING,
CHEST PAIN, DIFFICULTY IN BREATHING, DIFFICULTY IN SWALLOWING,
SEVERE ABDOMINAL PAIN, NAUSEA, VOMITING, DIARRHEA, COLLAPSE AND
UNCONSCIOUSNESS, TEARING
Medical Cond Aggravated by Exposure:PERSONS WITH PRE-EXISTING SKIN
DISORDERS, EYE PROBLEMS OR IMPAIRED RESPIRATORY FUNCTION SUCH AS
ASTHMA, BRONCHITIS, EMPHYSEMA MAY BE MORE SUSCEPTIBLE TO THE
EFFECTS OF THIS PRODUCT.

First Aid:GET MEDICAL ATTENTION IF SYMPTOMS PERSIST. EMPLOY FIRST AID
TECHNIQUE RECOMMENDED BY RED CROSS. IF BREATHING IS DIFFICULT,
PROVIDE OXYGEN/CPR. FOR ELECTRIC SHOCK, DISCONNECT POWER. FOR ARC
BURNS, APPL Y COLD, CLEAN COMPRESSES & CALL A PHYSICIAN. IF EYE
CONTACT, FLUSH WITH WATER FOR 15 MINUTES. IF INGESTED, CALL
PHYSICIAN/POISON CONTROL CENTER. IF SKIN CONTACT, WASH WITH SOAP &
WATER.

Flash Point Method:TOC
Flash Point:221F,105C
Extinguishing Media:WATER SPRAY, CARBON DIOXIDE, FOAM OR DRY CHEMICAL
FOR SURROUNDING FIRE. USE WATER SPRAY TO COOL FIRE EXPOSED
CONTAINERS.
Fire Fighting Procedures:WEAR FULL PROTECTIVE CLOTHING AND
NIOSH-APPROVED SELF-CONTAINED BREATHING APPARATUS WITH FULL
FACEPIECE OPERATED IN THE POSITIVE PRESSURE MODE.
Unusual Fire/Explosion Hazard:WELDING ARC AND SPARKS CAN IGNITE
COMBUSTIBLES.

Spill Release Procedures:WEAR PROPER PROTECTIVE EQUIPMENT. VENTILATE
AREA. NEUTRALIZE SPILLS WITH SODIUM CARBONATE. PLACE MATERIAL INTO
CLEAN CONTAINER FOR DISPOSAL. WASH SPILL AREA WITH WATER.
Neutralizing Agent:SODA ASH (SODIUM CARBONATE), TRI-SODIUM PHOSPHATE

Handling and Storage Precautions:STORE IN COOL, VENTILATED PLACE. KEEP
CONTAINERS TIGHTLY CLOSED. KEEP OUT OF REACH OF CHILDREN.
Other Precautions:CORROSIVE. DO NOT GET IN EYES, ON SKIN/CLOTHING.
AVOID BREATHING VAPORS/MIST/GAS. USE WITH ADEQUATE VENTILATION.
PROTECT CONTAINERS AGAINST PHYSICAL DAMAGE.

Respiratory Protection:USE NIOSH APPROVED SUPPLIED AIR RESPIRATORY
PROTECTION OR RESPIRABLE FUME RESPIRATOR WHEN WELDING, BRAZING OR
SOLDERING IN CONFINED SPACE OR WHERE LOCAL EXHAUST VENTILATION DOES
NOT KEEP EXPOSURE BELO W TLV.
Ventilation:USE GENERAL & LOCAL EXHAUST AT FLAME TO KEEP FUMES AND
GASES BELOW TLV'S IN THE WORKER'S BREATHING ZONE & GENERAL AREA.
Protective Gloves:WELDER'S GLOVE WHEN WELDING/RUBBER
Eye Protection:HELMET OR USE FACE SHIELD + FILTER LENS
Other Protective Equipment:EYEWASH AND SAFETY SHOWER SHOULD BE LOCATED
NEARBY.
Work Hygienic Practices:OBSERVE GOOD INDUSTRIAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. TRAIN WELDER NOT TO TOUCH LIVE ELECTRICAL
PARTS.
Supplemental Safety and Health

HCC:C1
NRC/State Lic Num:NOT RELEVANT
Vapor Pres:115
pH:2 - 3
Solubility in Water:SOLUBLE
Appearance and Odor:RED LIQUID - ODORLESS

Stability Indicator/Materials to Avoid:YES
NONE
Stability Condition to Avoid:NONE
Hazardous Decomposition Products:WELDING FUMES (OXIDES OF METAL BEING
WELD) AND GASES SUCH AS OZONE, CARBON MONOXIDE, CARBON DIOXIDE,
NITROGEN OXIDES...

Waste Disposal Methods:PREVENT WASTE FROM CONTAMINATING SURROUNDING
ENVIRONMENT. KEEP PERSONNEL AWAY. DISCARD ANY PRODUCT, RESIDUE,
DISPOSABLE CONTAINER OR LINER IN AN ENVIRONMENTALLY ACCEPTABLE
MANNER, IN FULL COMPLIANCE W ITH LOCAL, STATE AND FEDERAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.